SMarT-1 Documentation

The appropriate manual for the SMarT-1 Dialers can be found here: http://paulseward.com/downloads/smart_dialers/Doumentation/8350-383-113-BA_Issue_3.pdf

It’s a little hard to work your way through, but the following is the info required to program up port 1 as a speed dial, triggered by a single digit (eg for the duty officer mobile)

Reset to factory defaults
-------------------------
With a DTMF phone connected to an inbound port, and an outbound port connected to an exchange line, power off the dialler, press and hold the * key on the phone, power on the dialler, it will "click" as it disconnects from the exchange line, keep the * held down for 15-20 seconds then release.  This should reset the unit completely.

#0*      - to enter programming mode
942 903  - Reload factory defaults
942 904  - Clear all search tables

Set up exchange line 1
----------------------
100 2	Set exchange line 1 to Loop Start, MF4 (Search documentation for S00)
108 4	Set exchange line 1 "returned dial tone source" to exchange line (Search documentation for S08)

Set up incoming port 1
----------------------
127 1	Set port 1 default route to be "Route 1"  (Search documentation for R27)
110 1	Set port 1 to execute the default route immediately on off-hook
144 9	Return NU if Route 1 fails

Set up speedial
---------------
Configure the search table (Search documentation for "Search Tables")
801 #9 11 ##

801 = match a single digit
#9  = matches "any digit"
11  = forces the call into Route 1
##  = terminate programming sequence

615 00 05 09 04 04 08 00 00 00 ##
\_/ \________________________/ \/
 A              B               C

A = Access Control Sequence for Route 1 (Search documentation for 6R5)
B = The number to dial:
    01 = "1"
    02 = "2"
      ...
    09 = "9"
    0* = "*"
    10 = "#"
C is the terminator for the programming sequence

987 Save and exit programming mode